Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Trotec T510
Summary of Contents for Trotec T510
- Page 1 T510 OPERATING MANUAL MOISTURE MEASURING DEVICE...
-
Page 2: Table Of Contents
Follow the manual • Do not open the device. Information marked with this symbol indicates that the • Observe the storage and operating conditions as given in operating manual must be observed. the Technical data chapter. moisture measuring device T510... -
Page 3: Information About The Device
(e.g. gypsum, plaster). Observe Device description and comply with the technical data. The material moisture measuring device T510 enables the To use the device for its intended use, only use accessories and determination of the moisture content in wood and other soft spare parts which have been approved by Trotec. -
Page 4: Transport And Storage
Transport and storage Lower measured value indication (temperature) Note Temperature unit If you store or transport the device improperly, the Configuration mode device may be damaged. Note the information regarding transport and storage of the device. moisture measuring device T510... -
Page 5: Operation
In this case, the display shows either no measured values or they are incorrect. Wait a few minutes until the device has become adjusted to the changed conditions before carrying out a measurement. moisture measuring device T510... - Page 6 Performing the building moisture measurement Warning When handling the device there is a risk of injury due to the exposed measuring tips. Always put on the protective cap when not in use. moisture measuring device T510...
- Page 7 7. Repeat the steps 5. and 6. until the value is set as desired. measurement: -50 to +50 digits 8. Press the OK button (10) for approx. 2 seconds. ð The alarm was set based on your choice. moisture measuring device T510...
- Page 8 6. Press the OK button (10) for approx. 2 seconds. ð The offset is set. ð The device switches to measuring mode. ð With set offset value the indication CAL continues to be displayed whilst in configuration mode (18). moisture measuring device T510...
- Page 9 PC via a USB cable using the MultiMeasure prepare these for the measurement, if required. Studio software. ð For further information on suitable electrodes please 1. Briefly press the OK button (10). ® contact the TROTEC customer service. moisture measuring device T510...
-
Page 10: Table Of Wood Types
0.1 M% (see table of wood types printed version) (see table of wood types printed version) (see table of wood types printed version) (see table of wood types printed version) (see table of wood types printed version) moisture measuring device T510... - Page 11 Darr procedure or the CM method. • Oily and/or aqueous timber preservatives affect the measurement result. • If possible, do not measure wood with a temperature below -5 °C. Too low wood temperatures distort the result of the measurement. moisture measuring device T510...
- Page 12 Moisture content (M%) Measured value (digits) C 30/37 concrete (conversion not possible) Cementitious screed (conversion: CM% = M% -1.5 to 2) Cementitious floating screed (conversion not possible) Anhydrite floating screed (conversion: M% = CM%) moisture measuring device T510...
- Page 13 – drying may be required after evaluation of assessed, the spreading of the damp area can well be the damage characteristics determined. thorough moisture penetration – drying by use of technical means required All values are approximations and without warranty. moisture measuring device T510...
-
Page 14: Pc Software
You can only use all configuration, visualisation and functional options of ® the device when using this PC software and a TROTEC dongle (professional). Installation requirements Ensure that the following minimum requirements for installing... -
Page 15: Maintenance And Repair
Exchange the measuring tips when these exhibit signs of wear administration. For further return options provided by us please (e.g. oxidation, heavy contamination). See chapter Operation, refer to our website https://de.trotec.com/shop/. Installing the measuring tips. The separate collection of waste electrical and electronic... - Page 16 Trotec GmbH Grebbener Str. 7 D-52525 Heinsberg +49 2452 962-400 +49 2452 962-200 info@trotec.com www.trotec.com...