Tool Connector; Ethernet Cable Connector - Pro-face GP-2300 Series User Manual

Chapter 3 - Installation and Wiring
3.3

Tool Connector

The GP's Data Transfer Cable can be attached to the GP unit's Tool Connector.
To prevent an electric shock, unplug the GP unit's power
cord from the main power supply prior to attaching or de-
taching any connector(s) to or from the GP.
3.4

Ethernet Cable Connector

Use the following drawing to locate your GP unit's Ethernet connector. The GP
Ethernet interface is IEEE802.3 compatible, and transmits data at 10Mbps. (The
Ethernet I/F is not equipped on the GP-2301T.)
Ethernet Interface
(10BASE-T)
• It is strongly recommended that your Ethernet network is installed by a trained
engineer.
• You may not be able to use the 1:1 connection by a cross cable depending on PCs or
network cards. Be sure to connect those with a hub.
3-10
WARNING
Right Face
Left Face
(GP-2300 Series unit)
Tool Connector
GP-2300/2301 Series User Manual