Chapter 3 Installation And Wiring; Installation; Installation Procedures - Pro-face GP-2300 Series User Manual

Chapter
3 Installation and Wiring
3.1

3.1.1 Installation Procedures

Follow the steps given below when installing the GP.
Check the Installation Gasket's Seating
It is strongly recommended that you use the installation gasket, since it absorbs
vibration in addition to repelling water.
Place the GP on a level surface with the display panel facing downward. Check
that the GP's installation gasket is seated securely into the gasket's groove, which
runs around the perimeter of the panel's frame.
For details about installing the gasket, refer to
• Before installing the GP into a cabinet or panel, check that the instal-
lation gasket is securely attached to the unit.
• A gasket which has been used for a long period of time may have
scraches or dirt on it, and could have lost much of its dust and drip
resistance. Be sure to change the gasket periodically (or when
scratches or dirt become visible).
• Be sure to use gasket model PS300-WP00.
• Be sure the gasket's seam is not inserted into any of the unit's cor-
ners, only in the straight sections of the groove. Inserting it into a
corner may lead to its eventually tearing.
GP-2300/2301 Series User Manual

1. Installation

2. Wiring Cautions
3. Tool Connector
Installation
6.1.2 Installation Gasket Check/Replacement
4. Ethernet Cable Connector
5. CF Card Installation and Removal
GP
Rear face
Installation
Gasket
3-1