Table of Contents
Advertisement
2.1
Assembly
®
The assembled Eco Tech
shipped in a carton on a skid. Steps required for assembly are
as follows:
1. Remove the carton and the unit off the skid.
2. Install the feet into the threaded mounting locations on
the bottom of the unit.
3. Install a rack supports to the left & right insideof the
cooking cavity mounting holes.
4. Install the vent strainer in the back inside the cooking
cavity.
5. Mount the drip trough to the front of the unit.
6. Slide the ala-carte shelf into place on the slide guides.
2.2
Setting in Place
If possible, a location should be selected under an exhaust
hood which will remove small amounts of vapor emitted from
the cooker during normal operation. Next, level the unit after
it is placed in its final location. This is accomplished by turn-
ing the bottom part of the adjustable feet. Using the cabinet
top as a reference, obtain level adjustment left-to-right and
front-to-back. MAKE SURE UNIT IS LEVEL
2.3
Service Connections
The only service connection at the back of the unit is the
electrical connection. Please see the illustrations and table
located in Table 2.1 for service connections, details, and di-
mensions.
2.3.1 Electrical Connections
CAUTION: USE COPPER WIRE ONLY FOR POWER
SUPPLY CONNECTIONS.
Please refer to Table 2.1 for details of electrical service con-
nections.
Electrical connection power supply should utilize wire suit-
able for 90°C.
2. Installation
Pressureless Steam Cooker is
MODEL: ET-3E
VOLTS
208V
60Hz
240V
60Hz
480V
60Hz
MODELS: ET-5E & ET-6E
VOLTS
208V
60Hz
240V
60Hz
480V
60Hz
Note: ET-3E 9kW & ET-5/6E 12kW factory options
2.4
Reversing the Doors
®
The Eco Tech
Pressureless Steam Cooker has a reversible
cooking compartment door for your convenience. This sec-
tion contains instructions for reversing this door.
1. Turn off power to the unit.
2. Open the cooking compartment door
3. Remove the two screws that attach the top hinge to the
front of the unit.
4. Slide the door upwards, off the bottom hinge.
5. Remove the two screws that attach the bottom hinge to
the front of the units.
6. Remove the right and left side panels by unscrewing the
1 screw on each panel and sliding the panel down.
2-1
AMPS
6Kw
9Kw
PHASE
1 E
29
43
3 E
17
25
1 E
25
38
3 E
15
22
1 E
13
19
3 E
7
11
AMPS
PHASE
9Kw
12Kw
1 E
43
58
3 E
25
34
1 E
37.5
50
3 E
22
29
1 E
19
25
3 E
11
15
Table 2.0
Advertisement
Table of Contents
