Table of Contents
Advertisement
6. Maintenance
6.5
Control Panel Electrical
Service Access
The control panel assembly is mounted on the front of the
unit. It houses all the controls and indicators that are used to
®
operate the Eco Tech
. In order to service any of the control
panel electrical components, the control panel assembly must
be removed from the front of the unit.
CAUTION: Be sure to disconnect the power supply from
the unit before servicing any electrical components.
P
ROCEDURE
1. Remove the 6 screws that fasten the control panel as-
sembly onto the front of the unit.
2. Gently move control panel assembly out away from unit.
NOTE: A ground strap acting as a restraint prevents the
control panel from putting unnecessary strain on wires
and connections.
6.6
Door Adjustment
The cooking compartment door alignment, door handle ten-
sion, and latch tension are preadjusted at the factory during
assembly. During normal usage, these should not need any
attention. Note that when the cooking compartment doors
are reversed, as described in Section 2.3 of this manual, the
doors will need to be aligned and the door latch tension will
need to be adjusted (the door handle will not need adjust-
ment when the door is reversed).
(continued)
6-2
6.6.1
Door Alignment
The cooking compartment doors are prealigned at the fac-
tory during assembly and should not need adjusting unless
they are reversed. Should the doors need realignment, the
procedure is as follows:
P
ROCEDURE
1. Open the cooking compartment door.
2. Loosen all screws (2 per hinge) that mount the upper
and lower hinge brackets to the face of the unit using a
flathead screwdriver. DO NOT REMOVE THE
SCREWS.
3. Begin to retighten all 4 screws so that they are snug
against the face of the unit. DO NOT COMPLETELY
TIGHTEN THE SCREWS.
4. Slowly push the cooking compartment door closed until
it is latched.
5. The cooking compartment door can now be raised, low-
ered, and/or rotated into position by bumping it with the
palm of your hand or by using a small rubber mallet.
6. First, check the alignment at the front of the door by
making sure that the striker in the door is centered with
the latch mechanism on the front of the unit.
7. Square the door to the unit by raising or lowering the
hinge side of the door, keeping the latch centered with
the striker.
8. Visually inspect the door. Be sure that the door is square
to the unit, the striker is centered with the latch, and the
gasket is in contact with the entire lip of the cooking
compartment.
9. Gently open the cooking compartment door, taking care
not to move it out of position.
10. Tighten all 4 door hinge bracket mounting screws using
a flathead screwdriver.
11. Close and visually inspect the door again, as described
in Step 8.
Advertisement
Table of Contents
