Setting Communications Parameters (Snmp Protocol) - Huawei NetCol5000-C030H90D0 User Manual

NetCol5000-C(030, 032, 065) In-row Chilled Water
Smart Cooling Product
User Manual (2019)
Parameter
Client
encryption
Server
encryption
NMS IP
address
NMS port
number
----End

4.4.4.3 Setting Communications Parameters (SNMP Protocol)

Context
●
●
●
●
Procedure
Step 1 On the home screen, choose Settings > Comm Settings > SNMP Settings.
4-8
Figure 4-8 Setting SNMP communications parameters
Step 2 Set SNMP Version based on site requirements, and then tap Submit.
Issue 03 (2020-08-30)
Setting
Enable,
Disable
Enable,
Disable
N/A
N/A
To set communications parameters, log in as the admin user.
This section is suitable only for SNMP. Skip this section if you use Modbus.
Record the values entered in this section. They will be used when you access a
smart cooling product to an EMS (element management system).
One smart cooling product supports concurrent access of up to 6 EMSs
through SNMP.
is displayed.
Copyright © Huawei Technologies Co., Ltd.
Setting Method
This parameter is configurable when Link mode is
set to Client.
This parameter is configurable when Link mode is
set to Server.
Enter the actual IP address of the EMS. IP
addresses of the display panel, EMS client, and
EMS server must be unique. This parameter is
configurable when Link mode is set to Client.
It is recommended that you retain the default
value. If you need to change the value, enter a
value as required. This parameter is configurable
when Link mode is set to Client.
4 Commissioning
Figure
101