Installation - Njoy Eido 600 User Manual

3

Installation

The UPS can protect your equipment from all power
problems such as surge, spikes, blackouts, brownouts
and line noise. When AC power is present and the ON/
OFF switch is turned ON, the UPS is always charging
the battery and provides power to the equipment from
AC line directly. A reliable built-in battery can provide
stable power in order for you to complete your work,
save your data and safely shut down your system when
there is a utility power blackout.
Connecting your equipment and first usage
3.1
The UPS is simple to operate and install. Please read
the following steps before connecting any equipments
to this UPS:
Step 1. Connect the UPS to a grounded AC power
outlets.
Step 2. Please turn ON the ON/OFF switch and charge
the battery at least 8 hours for a full load
before you start to use the UPS.
Step 3. Plug your PC or peripheral equipment (printer,
tv, scanner, fax, speakers etc.) into the
power outlets of the UPS (these will provide
emergency battery backup power during mains
blackouts as well as surge protection from
surges and spikes).
04
CAUTION
Do NOT plug
LASER PRINTERS
into any of the
outlets.
Indicators & Alarm Table for Operation
3.2
Conditions Visual Indicator
AC Mode Green LED lighting
Green LED flashing
Battery Mode
every 10 seconds
Green LED flashing
Low battery at
every second and
battery mode
Red LED lighting
Fault Red LED lighting
Alarm for over-
Red LED flashing
temperature
every 0.5 seconds
protection
Do NOT plug any
SURGE STRIPS
into any of the
outlets.
Alarm
Off
Sounding every 10
seconds
Sounding every
second
Continuously
sounding
Off
05