Teknion hiSpace Table Operation Instruction page 2

Digital Handset Operation
1. Picture
2. Initialization procedure
step
Press and hold & together at the same
1
time for more than 10 seconds
2
Keep pressing &
3
Release & together
The initialization procedure must be completed before the first running after table is installed or parts replaced
3. Move up and down
step
1
Press and hold
2
Release
3 Press and hold
4
Release
4. Set memory positions
step
1
Press and hold or , then release
Click button M, then click button 1 or 2
2
or 3 within next 10 seconds
Memory Position cannot be set at lowest and highest height of the table
5. Move to the memorized positions
step
1
Press and hold the button 1 or 2 or 3
6. Change the display format
step
Press and hold button M, then press and
1
hold , keep about 10 seconds
2
Release the buttons
In inch format, the minimum height variation as the legs move up or down is 0.5 inches, while in centimeter
format is 1 centimeter
display screen
1
up
2
operation
operation
operation
operation
operation
m
down
3
motion
Legs begin to move down at a half speed
of normal operation
Legs move down to the lowest position and
rebound or click and then stop
Initialization is completed
motion
Legs move up
Legs stop
Legs move down
Legs stop
motion
Run the legs to the position you want the table
surface to be
Position 1 or 2 or 3 is saved
motion
Legs return to the corresponding position saved
motion
The height information will be changed between
centimeters and inches
completed