Commissioning - Wacker Neuson BS Series Operator's Manual

9 Operation and use
Hold the control handle left and right for an optimal control, performance and minimal hand-arm-

vibrations.
To avoid damage to the machine, the machine may not be relocated in a running state.

Use caution with coarse materials. In order to avoid extreme wear of the ramming shoe, this must

always strike parallel to the ground to be compacted.
Operation in channels
On pit, cavity, dump and embankment edges, on trench edges and terraces, operate the machine so

that there is no danger of tipping or falling over.
Pay attention to the sidewalls and their stability. Danger of collapse and burying!

Stability!

Operation below freezing
The cold oil in the percussion system can increase the resistance so much that the centrifugal clutch
slips.
Allow the machine to warm up at a low rpm, as otherwise the centrifugal clutch will wear quickly.

9.3

Commissioning

NOTICE
The machine must stand upright when starting and be placed on a suitable subsurface.
9.3.1 Start engine
WARNING
Hot silencer
Contact may cause burns.


CAUTION
Incorrect handling during starting can cause minor injuries.

NOTICE
Improper handling can damage the machine.


NOTICE
To start the engine, remove the engine at least 3 m from the refueling point.
22
Firmly hold the machine only by the control handle.
Wear protective gloves.
Only pull the starter rope if there is sufficient place and no people are in the immediate
vicinity.
Do not pull the starter rope all the way to the detent.
Slowly allow the starter rope to reel in again.
100_0201_op_0004.fm