Table of Contents
Advertisement
1. INTRODUCTION
This manual contains descriptive information on the operation, set up, and maintenance of the Defective Crimp
Cut-Off (DCC) unit installed on an AMP 3K or AMP 5K terminators. See Figure 1. The rear views are shown in
Figure 3. The DCC unit and terminator (DCC terminator) are used in conjunction with a crimp quality monitor.
When reading this manual, pay particular attention to DANGER, CAUTION, NOTE statements.
Denotes an imminent hazard which may result in moderate or severe injury.
DANGER
STOP
Denotes a condition which may result in product or equipment damage.
CAUTION
!
Highlights special or important information.
NOTE
i
Dimensions in this manual are in metric units [with U.S. customary units in brackets].
NOTE
i
For a description of the options available for the DCC unit, refer to Figure 2.
TE PART NUMBER
1424266-1
Most side-feed and end-feed heavy-duty mini applicators (with the exception of those listed below) can be run
on the DCC terminator. Both mechanical feed and air feed applicators can be run on the DCC terminator.
The following applicators will not run on the DCC terminator:
•
Closed barrel terminal applicators
•
Tab-Lok terminal applicators
•
Ultra-Pod terminal applicators
•
Applicators for terminals with stabilizer crimps
•
Applicators for terminals with center carriers
•
Applicators for center strip terminals
•
Applicators for gold splice terminals
•
Applicators for through-splice terminals
•
Applicators for right-to-left feed terminals
•
Other applicators for special terminal applications
For information concerning general terminator operation, refer to the AMP 3K and AMP 5K terminator customer
manual 409-10047.
For information concerning the operation of crimp quality monitor, 1320420-2, refer to the Crimp Quality Monitor
customer manual 409-10043.
Rev B
AVAILABLE OPTIONS
DESCRIPTION
Air Feed Valve Assembly -- 40 mm [1 5/8 Inch] Stroke
Figure 2
409-10064
4 of 26
Advertisement
Table of Contents
