One-Touch Type Reverse Feed Stitching Mechanism; Adjustment Needle Bar Stop Position - Garudan anita GC-3317 Series User Manual

ANITA ©

24. ONE-TOUCH TYPE REVERSE FEED STITCHING MECHANISM

The moment you press switch (1), the
sewingmachine performs reverse feed stitching.
The machine continues reverse feed stitching as
long as the switch is held pressed. When you
release the switch the machine resumes normal
stitching. (fig.19)
(fig.19)

25. ADJUSTMENT NEEDLE BAR STOP POSITION

A. Adjust of „UP" position
When the pedal is kicked down by heel the
machine stops at „UP" position. IF the marks
deviate larger than 3 mm, adjust as follows.
Disconnect the plug (12 pins) of cable from the
machine head. Run the machine and stop at
„UP position. While holding the handwheel,
insert the „adjusting tool" in the hole „A", then
remove tool.
B. Adjust of „DOWN" position
When the pedal is „Neutral" the machine stops
at „DOWN" position. If the marks deviate larger
than 5 mm, adjust as follows. Disconnect the
plug (12 pims) of cable from the machine head.
Run the machine and stop at „DOWN" position.
While holding the handwheel, insert the
„adjusting tool" in the hole „B", then remove
the tool.
Confirm the stop operation, then set the plug
(12 pins) coming from the machine head into
the receptacle. (fig.20)
(fig.20)
MP00100EN_170907 19