Uniden BCD396T Manual page 32

Easier to Read BCD396T/UBCD396T Digital Scanner Manual
Reviewing Locked Out Frequencies:
Scroll to 'Freq Lockouts' press E/yes.
Scroll to 'Rvw Search L/O' and press E/yes. If no frequencies are locked out, you will see 'Nothing Locked'.
Scroll to the frequency (or press (.)no to go to the next) and press E/yes to unlock the frequency.
Press Menu twice to return.
Unlocking All Frequencies:
Scroll to 'Freq Lockouts' press E/yes.
Scroll to 'Unlock All' press E/yes.
At 'Confirm?' press E/yes.
Press Menu to return.
Broadcast Screen
This setting determines whether the scanner automatically ignores transmissions that are on common broadcasts, paging systems, and other
annoyance radio sources during
Scroll to 'Broadcast Screen' and press E/yes.
Scroll to 1 of 4 options and press E/yes.
Set All Bands On - turns on broadcast screen on for all bands. Press Menu to return.
Set All Bands Off - turns off broadcast screen off for all bands. Press Menu to return.
Set Each Band - then scroll to each band and press E/yes to turn off or on. Press Menu to return.
Pager - the scanner skips known paging system frequencies.
FM - the scanner skips known FM frequencies.
UHF TV - the scanner skips known UHF TV frequencies.
Program Band - then scroll to the custom band (1-10) and press E/yes.
At 'Set Lower Limit' enter the lower limit of the frequency range and press E/yes.
At 'Set Upper Limit' enter the upper limit of the frequency range and press E/yes.
Scroll to the next band and repeat. Press Menu twice to return.
CTCSS/DCS Search
This setting controls whether the scanner will search for a
search. The default setting is Off.
Note: The scanner does not detect or decode a P25 digital signal if 'CTCSS/DCS Search' is turned on.
Scroll to 'CTCSS/DCS Search' and press E/yes.
Scroll to On or Off and press E/yes to save and exit.
Note: The scanner will not detect or decode P25 signals if you turn on CTCSS/DCS search only).
Repeater Find
This feature sets whether the scanner tries to tune to a repeater output frequency when it detects a transmission on a repeater input frequency in
Search and Close Call
modes. Since you can normally only hear one side of a conversation when you listen to an input frequency transmission, turning this feature
on can let you hear both sides of the conversation on the output frequency. If the scanner detects the transmission on the output frequency, it beeps and 'Repeater
Found' appears, and it remains on the output frequency until transmissions end. The default setting is off.
Scroll to 'Repeater Find' and press E/yes.
Scroll to On or Off and press E/yes to save and exit.
Max Auto Store
This value sets how many hits the scanner will automatically store when it is in either
scanner reaches the maximum number of hits you set, it stops the auto-store operation.
Scroll to 'Max Auto Store' and press E/yes.
Enter a value from 1-256 then press E/yes to save and exit.
http://marksscanners.com/396/396.shtml (32 of 51)8/17/2010 10:11:40 PM
Custom Search, Service Search, or Close Call Search. Note: Broadcast screen is not effective during some service searches.
VHF TV - the scanner skips known VHF TV frequencies.
NOAA WX - (not w/UBC396T) the scanner skips known NOAA weather
frequencies.
Band 1-10 - the scanner skips known frequencies for custom broadcast ranges.
subaudible tone when it stops on a transmission during
Search and Store
Searching and Close Call
or Close Call Auto Store mode. When the
Contents