Close Call Auto Store - Uniden BCD396T Manual

Easier to Read BCD396T/UBCD396T Digital Scanner Manual
When the scanner detects a Close Call signal, 'CC Found!' and 'Press Any Key' appear for the length of time set in
Press any key (except Hold) to display the frequency for the delay time set in
press Hold. Press Hold again to resume. See
To hold on a CC hit
press 'Any key' then E/yes then see
To save a frequency
To cancel a CC hit turn the scroll control.
press L/O.
To lock out the frequency
press Hold. Press Hold again to resume.
To view the last CC hit
To turn the attenuation on or off (for all bands)
press Scan.
To exit CC only
Notes: The Close Call feature does not work for frequencies greater than 956 MHz.
While scanning or searching with Close Call Override set to
audio and goes to the Close Call hit.
'CC Found!' and 'Press Any Key' appear for the length of time set in
will return to scanning.
Press any key (except Hold) to listen to and display the frequency for the delay time set in
Quickly press Hold to stay on the frequency. Press Hold again to resume.
While scanning or searching with Close Call Override set to
current audio.
'CC Found!' and 'E to Listen' appear for the length of time set in
Press E/yes to listen to and display the frequency for the delay time set in
Quickly press Hold to stay on the frequency. Press Hold again to resume.
While in Hold mode:
press E/yes then see
To save a frequency
press L/O.
To lock out the frequency
To start a 'Quick Search' at the current frequency
To check for a repeater frequency

Close Call Auto Store

Allows you to automatically store Close Call hits into channels. If you turn this feature on, the scanner mutes, starts Close Call Only mode, and stores any Close Call hits
from the bands selected in 'Set CC
and 'Search and Store' appears in the display. When the scanner finds an active transmission, it checks to see if the frequency has already been stored in the system.
If the frequency has already been stored, the scanner continues to search. If the frequency has not been stored, it stores the frequency into a (created) system called
'Close Call' and a (created) group named 'Found Channels' then resumes searching. This new system and group have the same options as any conventional system/
group and can be edited the same way.
Scroll to 'CC Auto Store' and press E/yes.
'Limit Reached' will appear in the display when the Max Auto Store value is reached.
Press Scan to exit.
http://marksscanners.com/396/396.shtml (39 of 51)8/17/2010 10:11:40 PM
Programming a Displayed
press and hold Func then E/yes(att) to toggle on or off.
Close Call
Programming a Displayed
turn the scroll control then press Hold.
quickly press Hold to hold on the frequency. Press and hold Func then press and hold .no(rev). Press Hold to resume.
Bands' up to the maximum you specified in the
Weather Operation Menu
Search/Close Call Options (even if it's gone).
Close Call Hold Mode.
Frequency.
On, when the scanner detects a Close Call signal, the scanner overrides the current
(or until the signal is lost if longer). If you do not press 'Any Key', the scanner
Close Call Pause
Search/Close Call Options
Off, when the scanner detects a Close Call signal, the scanner does not override the
Pause. If you do not press E/yes, the scanner will return to scanning.
Search/Close Call Options (only if it's still there).
Frequency.
'Max Auto Store' setting. The scanner looks for active frequencies within the range(s)
(not w/UBCD396T)
Close Call Pause (or until the signal is lost if longer).
(even if it's gone).
Contents