Operation - Yard force YF3100ES-R Operator's Manual

HOW TO USE YOUR PRESSURE
WASHER
If you have any problems operating your pressure washer,
please call the Yard Force helpline at 1-866-902-9690.
Pressure Washer Location
Carbon Monoxide Poisoning
WARNING! POISONOUS GAS HAZARD.
Engine exhaust contains carbon monoxide, a
poisonous gas that could kill you in minutes.
You CANNOT smell it, see it, or taste it, Even if you do not
smell exhaust fumes, you could still be exposed to carbon
monoxide gas.
• Operate this product ONLY outside far away from
windows, doors and vents to reduce the risk of carbon
monoxide gas from accumulating and potentially being
drawn towards occupied spaces.
• Install battery-operated carbon monoxide alarms or
plug-in carbon monoxide alarms with battery back-up
according to the manufacturer's instructions. Smoke
alarms cannot detect carbon monoxide gas.
• DO NOT run this product inside homes, garages,
basements, crawlspaces, sheds, or other partially
enclosed spaces even if using fans or opening doors
and windows for ventilation. Carbon monoxide can
quickly build up in these spaces and can linger for hours,
• ALWAYS place this product downwind and point the
engine exhaust away from occupied spaces.
If you start to feel sick, dizzy, or weak while using this
doctor. You may have carbon monoxide poisoning.
Exhaust port pointed away
from occupied spaces

OPERATION

Risk of Fire Clearances
WARNING Exhaust heat/gases could ignite
combustibles, structures or damage fuel tank
• Keep at least 5 ft. (1.5 m) clearance on all sides of
pressure washer including overhead.
To Start Your Pressure Washer
time, follow these instructions step-by-step. This starting
information also applies whenever you start the engine after
you have let the pressure washer sit idle for at least a day.
1.Place pressure washer outside near an water source
gallons per minute and no less than 20 PSI at pressure
washer end of garden hose.
2.Check that high pressure hose is tightly connected to
spray gun and pump.
3.Make sure unit is in a level position.
CAUTION! Do Not run the pump without the water supply
connected and turned on.
• Damage to pressure washer resulting from failure to
follow this instruction will void warranty.
4.Turn ON the water, point the spray gun at a safe
direction, release the trigger lock, then squeeze
trigger to purge the pump system of air and impurities.
5.Choose the quick-connect nozzle you want to use, pull
back on collar of spray wand , insert the nozzle and
release collar. Tug on the nozzle to make sure it is
securely in place.
6. Engage the trigger lock on the spray gun.
7. Push engine On/Off to On (I) position.
11