Advertisement
8.
Recoil start.
Stand behind the machine,hold the handle firmly with
one hand. Pull the starter handle out 10-15cm/4-6'' until
you feel a resistance and then start the engine with a
sharp pull. You can also use remote control to start your
pressure washer, see "Remote Control Mode" section.
9.Squeeze trigger for more than 5 seconds until there is
a steady stream of water.
Hold for 5 seconds
WARNING!
Risk of eye injury.
Spray could splash back or propel objects resulting
in serious injury.
• Always wear indirect vented (chemical splash) safety
goggles marked to comply with ANSI Z87.1 when using
or in vicinity of this equipment.
• NEVER substitute safety glasses or dry-condition
goggles for indirect vented safety goggles.
How to Stop
Your Pressure Washer
1. Release trigger
.
2. Push engine On/Off switch to OFF (O) position. Or you
can use the remote control to stop the engine see "Remote
Control Mode" section.
WARNING!
• Every time when you stop engine, ALWAYS point spray
gun at safety direction, release thetrigger lock, and
squeeze spray gun trigger to release high pressure.
NOTICE:
A small amount of water will squirt out when you
release the pressure.
3. Put the spray gun back to the gun holder.
Remote Control Mode
The pressure washer has been matched with the remote control.
When using this function for the first time, please make sure that
• The battery pack is well charged and well installed.
• The green breathing light on the battery pack tank flashes at a
frequency of once per second.
• Make sure the engine On/Off switch is on (I) position. Then you
can take out the remote control from the spray gun to start using
your remote control function.
1. Press the Start button on the remote control to start the engine.
2. Press the STOP button, the engine will be powered off.
NOTICE:
1. The max control distance is 100 feet without obstacles blocking.
2. With a fully charged battery pack, it can reach almost 100 times
starts.
Servo function of the remote control.
When there is no operation for one hour, the remote function will
be automatically turned off to save power. To resume the remote
control function, you can press the remote control connection button
on the breathing light or reinstall the battery pack.
Matching your remote control.
When the remote control function is abnormal, or if the remote
control is damaged or lost and replace a new remote control, you
need to match the remote control to your pressure washer.
1. Press and hold the remote control connection button on the
breathing light for at least 3 seconds and you will see the green light
flashes as the frequency of twice per second.
12
Switch ON
Switch OFF
Hide quick links:
Advertisement
