Page 1
LW C02 Q0W-SP01-320 20V CORDLESS PRESSURE WASHER AQUAJET Original Instructions READ & UNDERSTAND INSTRUCTION MANUAL Save all warnings and instructions for future reference. Service centre: +44(0)1904727513 Mail: support@yardforce.co.uk Web: www.yardforce.eu...
Page 2
Read this manual carefully prior to assembling and operating the pressure washer. It is dangerous to operate this product without being familiar with these instructions. Keep this manual in a safe place and have it ready for future reference.
LW C02 Original Instructions CONTENT Intended use General safety warnings Product safety warnings Symbols Technical data Description of product Installation Operation Maintenance and storage Troubleshooting CE declaration...
INTENDED USE The appliance is intended for cleaning the walls of buildings, facades, terraces, footpaths, garden equipment, appliancery, vehicles and tools. The appliance is to be used only for its prescribed purpose. Any other use is deemed to be a case of misuse. The user/operator and not the manufacturer will be liable for any damages or injuries of any kind caused as a result of misuse.
Page 9
GENERAL SAFETY WARNINGS 3. WARNING: This appliance has been designed for use with the cleaning agent supplied or recommended by the manufacturer. The use of other cleaning agents or chemicals may adversely affect the safety of the appliance. 4. WARNING: Pressure jets can be dangerous if subject to misuse.
Page 10
GENERAL SAFETY WARNINGS 14. WARNING: Always remove the battery pack when leaving the appliance unattended. 15. WARNING: In the event of contact with or spillage of detergents, flush with water. If liquid contacts eyes, seek medical assistance immediately. 16. The liquid from appliance must not be directed towards equipment containing electrical components, such as the interior of ovens.
PRODUCT SAFETY WARNINGS WARNING! When using the product, the safety rules must be followed. For your own safety and that of bystanders, please read these instructions before operating the product. Please keep the instructions safe for later use. Training 1. Read the instructions carefully. Be familiar with the controls and the proper use of the product.
Page 12
PRODUCT SAFETY WARNINGS approved by IEC 61770. 3. WARNING: Pressure hoses, fittings and couplings are important for the safety of the appliance. Use only hoses, fittings and couplings recommended by the manufacturer. Operation 1. Use the product only in daylight or good artificial light. 2.
Page 13
PRODUCT SAFETY WARNINGS provided or recommended by the manufacturer. 9. Avoid using the product in bad weather conditions especially when there is a risk of lightning. 10. Do not expose the product to rain. Battery pack 1. Fully charge battery pack before first use. 2.
Page 14
PRODUCT SAFETY WARNINGS other metal objects such as paperclips, coins, keys, nails, screws or other small metal objects that can make a connection from one terminal to another. 11. Only use the authorised battery pack by maufacturer. model: B0P-SP07-20-ZJ. Charging 1.
Page 15
PRODUCT SAFETY WARNINGS risk of electric shock. 9. Battery will heat up whilst charging. To reduce the risk of fire, do not operate battery charger on flammable surfaces such as paper or textiles. 11. Only use the authorised charger by maufacturer. model: B0Q-SP06-20ZB.
Page 16
PRODUCT SAFETY WARNINGS Take the following points into account to minimize the vibration and noise exposure risks: 1. Only use the product as intended by its design and these instructions. 2. Ensure that the product is in good condition and well maintained.
SYMBOLS Safety symbols The purpose of safety symbols is to attract your attention to any possible dangers. The safety symbols and their explanations deserve your careful attention and full understanding. The symbol warnings do not, by themselves, eliminate any danger. The instructions and warnings they give are no substitute for proper accident prevention measures.
Page 18
SYMBOLS To reduce the risk of injury, user must read instruction manual carefully. Appliance not suitable for connection to the potable water mains (kitchen tap). Water that has flown through backflow preventers is considered to be non-potable. The appliance is not intended to be connected an indoor tap.
Page 19
SYMBOLS Warning symbols on the battery pack To reduce the risk of injury, user must read the instruction manual carefully. Do not throw into water. Do not throw to fire. Do not subject the battery to strong sunlight over long periods of time. Do not leave on a heater (max.45°C).
Page 20
SYMBOLS Warning symbols on the charger To reduce the risk of injury, user must read the instruction manual carefully. The charger is for indoor use only. Double insulation WEEE symbol. Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
TECHNICAL DATA Model LW C02 Nominal voltage of product 20 V / 2.5 Ah with battery water inlet pressure < 6 Bar Working pressure Eco: 14 Bar High: 22 Bar Flow rate 370 L/h Weight 4.5 kg Battery pack Model B0P-SP07-20-ZJ Battery capacity 2.5 Ah...
Check the delivery parts (Fig. B) Remove the appliance from its packaging carefully and make sure that all of the following parts are present: a. 3 in 1 nozzle b. AQUAJET housing c. Hose d. Extension lance e. Battery pack f.
INSTALLATION Install the extension lance (Fig. C) 1. Press the extension wand into the gun. (You will feel a slight spring resistance) 2. Secure the attachment by twisting. Fitting the 3 in 1 nozzle (Fig. D) Press the hold button on the extension lance, and then fit it into the 3 in 1 nozzle, make sure nozzle is locked in position.
Page 24
Insert the battery pack with moderate force until it was locks in to place. WARNING: Only use Yard force 20V original battery pack! To remove the battery pack from the tool (Fig. J) 1. Press the battery pack release button.
Switch OFF: Release the switch trigger. Operating the AQUAJET Adjusting rotary handle: This device is equiped with the handle that can be adjusted. Press the rotary handle button and keep it in place, adjust hanlde as in the picture shown. (Fig. M) Adjusting working pressure: Press the Eco/Pressure switch button to switch Eco/HIGH working pressure.
MAINTENANCE AND STORAGE WARNING: Risk of electric shock Before performing any repair work, always ensure that the battery pack has been removed. Overview of cleaning 1. Clean the appliance. Wipe the unit with a slightly damp cloth. Do not clean the appliance using a high-pressure water jet.
Page 27
MAINTENANCE AND STORAGE Battery maintenance Use the following procedures to achieve the best battery life: 1. Protect the battery against moisture and water. 2. We recommend to store the battery only within temperature range of 5 ℃ to 45 ℃ . Do not leave the battery in direct sunlight for extended periods of time.
TROUBLESHOOTING WARNING: Before performing any repair work, always ensure that the battery pack has been removed. Fault/ Cause Remedy malfunction Battery pack discharged? Fully charge the battery pack Battery pack is not connected correctly dis charged Install the battery pack once again. place correctly.
CE DECLARATION Declaration of Conformity SUMEC UK Unit A&B Escrick Business Park Escrick, York YO19 6 FD Declare that the product: Description: 20V Cordless Pressure Washer Q0W-SP01-320 LW C02 Function: Clean the walls of buildings etc. Complies with the essential health and safety requirements of the following directives: Low Voltage Directive 2014/35/EU EC Directive 2011/65/EU and its amendment Directive (EU) 2015/863 (RoHS) Standards and technical specification referred to :...