Assembly - Yard force YF3100ES-R Operator's Manual

Your pressure washer requires some assembly and is ready
for use only after it has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of your
pressure washer, please call the Yard Force helpline at
1-866-902-9690.
IMPORTANT: Any attempt to run the engine before it has
been serviced with the recommended oil will result in an
engine failure.
UNPACK THE PRESSURE WASHER
• Remove everything from carton except the pressure
washer.
• Open carton completely by cutting each corner from top to
bottom.
• Remove pressure washer from carton.
CARTON CONTENTS
Check all contents. If any parts are missing or
damaged, call the Yard Force helpline at
1-866-902-9690.
A
C D
G H
A- Main unit
●
B- Upper handle Unit
●
C- Spray gun
●
D- Spray wand
●
E- Li-ion 20V Battery Pack
●
F- 20V Battery Charger
●
G- High Pressure Hose
●

ASSEMBLY

B
E F
I J
H- Remote Controller
●
I- Manual (with needle inside)
●
J- Engine oil (SAE 30 16 o.z.)
●
Become familiar with each piece before assembling the
pressure washer. Check all contents against the illustration.
If any parts are missing or damaged, call the Yard
Force helpline at 1-866-902-9690.
ASSEMBLING YOUR PRESSURE WASHER
1. Install the upper handle unit
Install the upper handle like picture shows below, make sure
this upper handle snaps into a locked position.
2. Hook the hose onto the hose holder.
7