Operation - Yard force AQUAJET 2 Original Instructions Manual

OPERATION

To insert the battery pack (Fig. G)
1. Open the battery door, by lifting up the door latch lever and rotating it with the battery
door.
2. Align the groove on the battery pack with the corresponding ribs in the receptacle of the
device.
3. Insert the battery pack with moderate force until it locks into place.
4. Close the battery door and place the catch over the housing lock and then depress the
latch lever- make secure the door is fully securely closed.
WARNING:
Only use Yard Force 20V original battery pack!
To remove the battery pack from the tool (Fig. H)
1. Open the battery door, by lifting up the door latch lever and rotating it with the battery
door.
2. Press the battery pack release button.
3. Remove the battery pack from the tool.
Choose your water source (Fig. I)
1. Using the Aquajet with your garden hose pipe – attach the hose pipe to the Aquajet
connector and make sure that it is locked into position.
2. Using the Aquajet with a portable water source – assemble the filter to the short portable
hose pipe supplied with the product and then connect the other hose connector to the
Aquajet connector and place into the water source.
Connect the hose
Attach the hose to the Aquajet connector, make sure it is locked in to position when you hear
the sound "click" .
In keeping with current regulations a pressure washer must never be operated from the
drinking water mains supply without a controllable backflow preventer. A suitable backflow
preventer in conformity with EN 12729 type BA must be used.
Water that has passed through a backflow preventer is classified as undrinkable.
NOTE: A backflow preventer is available from specialist retailers.
NOTE: Water pressure out from the tap should not higher than 0.6 MPa.
24
OPERATION
Switch ON (Fig. J)
1. Press the safety lock button with your thumb.
2. Depress the switch lever. Once the machine has started then release your thumb from
the lock button.
3. Hold the trigger down, if using the portable water source, it will take at least 15 seconds
to draw the water from the source.
NOTE
: Be prepared for the recoil force of the emitted water jet! Ensure that you are standing
firmly and that you are holding decive securely with both hands, otherwise you could injure
yourself or other people.
Switch OFF
Release the switch trigger.
Operating the AQUAJET 2
5 in 1 nozzle (Fig. K)
Whilst holding the lance rotate the nozzle to your selected position making sure that the
nozzle is aligned with the lance arrow
Using the brush (Fig. L)
Remove the lance and nozzle.
Align the brush to the main housing and push down firmly and rotate to secure in place.
Using the foam sprayer
1. Fill the bottle with detergent, using the brands recommended mixture levels. (Fig. M)
2. Align the detergent bottle to the main housing and push down and rotate to secure in
place. (Fig. N)
WARNING:
Risk of electric shock
Before performing any repair work, always ensure that the battery pack has been removed.
25