Advertisement
Carburetor Adjustment
The carburetor on this engine is low emission. It is equipped
with a non-adjustable idle mixture valve. Top speed has
been set at the factory. If adjustment is required, see an
authorized service dealer.
CAUTION! Excessively high operating speeds could
result in minor injury.
Excessively low speeds impose a heavy load.
• DO NOT tamper with governor spring, links or other parts
to increase engine speed. Pressure washer supplies
correct rated pressure and flow when running at
governed speed.
• DO NOT modify pressure washer in any way.
After Each Use
Water should not remain in pressure washer for long period
of time. Sediments or minerals can deposit on pump parts
and "freeze" pump action. Follow these procedures after
every use:
safety direction, release trigger lock and squeeze trigger
of spray gun to relieve
cool.
WARNING! The high pressure stream of water that
pressure washer produces could cut through skin
ant its underlying tissues, resulting in serious injury
and possible amputation.
Spray gun traps high water pressure, even when engine is
stopped and water is disconnected, which could result in
serious injury.
Keep high pressure hose connected to pump and spray
gun while system is pressurized.
ALWAYS point spray gun in safe direction, release trigger
lock and squeeze trigger of spray gun p to release high
pressure, every time you stop engine.
2. Disconnect hose from spray gun. Drain water from hose,
3. Empty pump of all pumped liquids.
4. Store the spray gun, wand, nozzles
5. Store the pressure washer in a clean, dry area.
6. If storing for more than 30 days see "Long Term Storage"
on next page.
trapped pressure and let engine
WARNING! Fuel and its vapors are extremely
flammable and explosive which could
death or serious injury.
WHEN STORING FUELOR EQUIPMENTWITH FUEL IN
TANK
• Store away from furnaces, stoves, water heaters, clothes
dryers, or other appliances that have pilot light or other
ignition source because they could ignite fuel vapors.
Remote Control indicator meaning
Green light flashing
s
(2Hz during matching)
Green light flashing
(2.5Hz when normal
operating)
NOTICE:
When pressing the buttons on the remote control, if the red LED
is not illuminated, please replace the remote control battery. To
replace the battery, please open the back of the remote control,
change two old cells with two new batteries. (Battery type: CR2016)
To buy a new remote control, please call the Yard Force helpline
at 1-866-902-9690.
20
Matching model
Overcurrent, restart the machine
Battery pack lack of power,
charge the battery
Battery pack overheat, let is cool
for a while, and then try again.
Hide quick links:
Advertisement
