Table of Contents
Advertisement
17. Ensure the inside line on
the bottom vent slot of the cap
(17) lines up with the seam on
the dual valve body (13).
18. Place the cord hook through
the large diameter end of the
spiral hose (24). Compress the
hose to expose the hook out the
opposite end. Use the cord hook
to pull the braided spectra cord
(23) though the small diameter
end of the hose.
19. Apply a small amount of Gasgacinch to the diameter of the dual
valve body (13), allow 15 seconds to get tacky. Slide the spiral hose
(24) onto the dual valve body.
Gasgacinch
20. Lightly fasten a clamp (22) over the spiral hose (24) so that it
captures both the hose and dual valve body (13). Position the end
of the clamp to either side and pull the end of the clamp sufficiently
snug. Trim the excess length with a pair of diagonal pliers
21. Insert retaining pin (28) half way into one hole of the airway body
(30). Slide the spiral hose (24) back and capture both loop ends of
the braided spectra cord (23) using your thumb and index finger
facing up. Rotate your wrist pointing your thumb and index finger
down to form a "Larks Head Knot" on both loop ends. Capture the
knot onto the retaining pin.
Align
Here
22. Press the pin (28) into the airway body (30) by hand until
it engages equally into both holes. Apply a small amount of
Gasgacinch to the outer diameter of the airway body (where the
spiral hose attaches), allow 15 seconds for the adhesive to get
tacky. Slide the spiral hose (24) onto the airway body with the
mouthpiece facing to the right hand side of the user as worn.
23. Secure each of the two clamps
(22) to the spiral hose (24). The
outside clamp head faces in-line
with the mouthpiece. Clamp edge
distance to the end of the hose
is 3.18mm (1/8 inch). The other
clamp faces the opposite direction
over the retaining pin (28).
Please Refer to Final Assembly and Testing
section of this manual.
25
Gasgacinch
Clamp 2
Clamp 1
Advertisement
Table of Contents
