Donning And Adjustment Procedures; Donning And Adjustment - Aqua Lung ODYSSEA Technical Manual

DONNING & ADJUSTMENT PROCEDURES
Donning and Adjustment (Figs. 12 & 13)
1. One end of the back strap has a male quick-release
buckle (A). Connect the male buckle to the female
buckle at the top of the BC. Secure the excess webbing
through the 3-bar slide (B).
2. Connect the waist strap male buckle (C) to the
female buckle located on the side lobe of the BC.
Insert the free end of the waist strap through the
sewn-in loop (D) on the back strap.
3. Insert your arm through the straps as if you were
putting on a jacket. Reach back with one hand and
grab the free end of the waist strap. Connect the
second male buckle (C) to the female buckle on the
side lobe of the BC.
F
B
E
Fig. 13
4. Bring the free end of the crotch strap between your
legs and connect the male buckles to the two lower
female buckles at the front of the BC (E).
5. Connect the male buckle (F) to the female buckle
on the chest strap, this is located just above the
crotch strap.
NOTE: When using front mount UBA, the chest
strap will go around the outside, securing it close
to the body.
6. The length of the straps may be adjusted by holding
the strap and moving the 3-bar slide. After adjusting
the position of the 3-bar slide, readjust the strap
through the quick release buckle. Ensure any excess
webbing is secured back thorough the 3-bar slide.
7. Once the straps are re-adjusted, don the BC to
make sure the adjustments are correct.
A
B
C
C
D
B
Fig. 12
15