Omron NA Series Practices Manual page 22

 Screen Specifications
・ Reads and displays the device information on the IO-Link master unit NXR-ILM08C.
EIP Status
・ Reads and displays the information on Ethernet port connection statuses.
Screen
・ Displays logs of FCS errors and outputs to an output variable.
4
6
7
8
9
10
16
No. Part
1 DataDisplay
2 Group
3 Button
4 Button
5 Group
6 Button
7 Lamp
8 Button
9 Button
10 Button
22
2
11
13
17
18
Description
IP address of the selected device is displayed.
Units' information is shown. Refer to No. 16 and later for details.
The LED that indicates the location of the IO-Link master unit on the screen is lit when
this button is pressed.
It is for expansion and not shown in the actual NA.
Displays connection conditions of ETH1 and ETH2 by any of the following:
Undiagnosed, Normally communicating, Short-circuited, Disconnected, Making a
diagnosis, Failed to read, or Other error.
Default: Undiagnosed
If ETH1 and/or ETH2 is disconnected, indications that notify a disconnection and a
distance to the disconnected point are shown.
Pressing the Start Logging button begins logging FCS errors.
If the number of FCS errors per sampling cycle excesses to a threshold, results are
stored to IO variables, LogPort□FCSErrorCount and LogPort□FCSErrorTime.
Pressing the Stop Logging button stops logging, but results are not stored.
Displays the progress of logging by any of the following:
Logging, Logging paused/Results found, Logging paused/No results, or Abnormal
logging termination/No results
It is for expansion and not shown in the actual NA.
Clears the value of the array variable in which logs are stored to zero. The integrated
value of FCS errors also becomes zero.
Save logging results to a file. It is for expansion and not shown in the actual NA.
1
5 5
12
6
7
8
9
10
14
19
20
3
4
12
11
13
15
21