Omron NA Series Practices Manual page 14

 Screen Specifications
IO Status Displays the information of the IO-Link master unit whose IP address is notified externally.
Screen
8
No. Part
1 DataDisplay
2 Group
3 Button
4 Button
5 DataDisplay
6 Button
WordLamp
7 Button
8 Lamp
9 Lamp
10 Lamp
11 Lamp
12 Lamp
13 Lamp
14
2
7
5 6
9 10
Description
IP address of the selected device is displayed.
Unit status is displayed. Refer to No. 8 and later for details.
The LED that indicates the location of the IO-Link master unit on the screen is lit when
this button is pressed.
It is for expansion and not shown in the actual NA.
Displays Device Information Window.
Displays pin modes of Pin4 (upper) and Pin2 (lower) for each IO port as the following.
Pin4: Any of Disabled, DI, DO, or IO-Link
Pin2: Any of Disabled, DI, or DO
Displays statuses of Pin4 (upper) and Pin2 (lower) for each IO port as the following.
Pin4: Any of Disabled, ON, OFF, Communicating with IO-Link Unit, Error in IO-Link
Unit, Short circuit detected, or Not connected.
Pin2: Any of Disabled, ON, OFF, Short circuit detected, or Not connected.
Pressing the Pin4 button when Communicating with IO-Link Unit or Error in IO-Link Unit
is being displayed executes the event ShowPortStatusEvent.
Connected device name is displayed only when the pin mode is IO-Link; otherwise, "-"
is displayed.
Executes events for connected devices.
For NXR-D Series Units, the event SelectNXR_D_SeriesEvent is performed.
Unit status is displayed.
Network condition is displayed.
Displays EtherNet1 port condition.
Displays EtherNet2 port condition.
Displays the condition of the input power supply voltage.
Displays the condition of the output power supply voltage.
1
3
7
5 6
12
11
4
13