Eiki LC-XNS2600 Service Manual page 9

Maintenance and cleaning
Replace the lamp
When the projection lamp of the projector reaches its end
of life,the Lamp replacement icon appears on the screen,
please replace the lamp immediately.
FORBIDDEN
As temperature inside the projector is high, you should
cool the projector for at least 45 minutes before you
open the lamp cover.
Note
When the lamp isn't illuminated, it may indicate that the lamp has been damaged.
When you replace the lamp in a projector installed on the ceiling, you should stand beside the lamp cover but not
under it; for the broken glass may fall down to hurt you. To do that, remove the lamp cover gently to avoid being
hurt by the dropped glass. If glass drops into your eyes or mouth, you should see the doctor immediately.
To replace the lamp, follow the steps below:
1. Power off the projector and unplug the power cord.
Then let the project cool for at least 45 minutes.
2. Loosen the screws on the lamp cover to remove the
cover.
3. Make sure the lamp is well protected and remove three
screws. Hold the handle to take out the lamp.
4. Install a new lamp with the same model and tighten the
three screws. Make sure the installation is correct. Put
lamp cover in place and then tighten the screw.
5. Plug the AC power cord and power on the projector.
Lamp replacement icon
Lamp replace
CAUTION
For the sake of safety, only use the lamp of the same
model. Never drop the lamp onto the ground nor touch
the glass bulb! The glass can shatter and hurt.
Handle
Lamp cover
-9-
Screw
Screw