Troubleshooting; Indicator And Projector Status - Eiki LC-XNS2600 Service Manual

Troubleshooting

Indicator and projector state
Check the indicator to know about the state of projector.
Indicator
POWER WARNING
(Green/Red/Orange)
?
....Green
....
Green flash
* When the lamp reaches the end of its life, the WARNING indicator lights red. In this case, replace the lamp with a new
one promptly.
(Red)
The projector is off. (AC power cord not connected).
The projector is operating normally.
- In standby mode. Press POWER to power on the projector.
- When the projector is cool enough, the temperature is restored
to the normal value, you can turn on the projector. And the
POWER indicator stops flashing.
Internal temperature too high and can't be turned on. When the projector is
cool enough, the temperature is restored to the normal value and the POWER
indicator lights red, you can turn on the projector .
In power management mode.
Ready for standby mode or the lamp is being cooled. Before you turn on
the projector, you should wait till the lamp is cool enough and the POWER
indicator flashes.
Can't be turned on because error is detected. You should unplug the
power cord. Then insert it again and power on the projector. If the projector
is powered off again, you should cut off the power and contact the local
distributor or repair center. In this case, stop the projector. Otherwise, electric
shock or fire may occur.
The service life of the lamp is over. You should replace it with a new one in
time.*
? ....
Orange
....
Red
?
.... ....
Red flash Orange flash
State of projector
....
Off
-42-