Lamp Replacement
Suggestion
f the filter is blocked by dust, the effect of cooling fan will be reduced, and heat accumulate in the projector, service life will
be shortened.shorten the service life of the lamp. Cleaning filter is suggested after lamp replacement.Replacement Refer
to "Clean the filter".
How to check Lamp Used Time
The LAMP REPLACE indicator will light yellow when the total
lamp used time (Corresponding value) reaches 5,000
hours. This is to indicate that lamp replacement is required.
The total lamp used time is calculated by using the below
expression,
Total lamp used time (Corresponding value) = Teco + Tnormal
x 3/2
Teco : used time in the Eco1 and Eco2 mode
Tnormal : used time in the Normal mode and Auto mode
You can check the lamp used time following to the below
procedure.
Press INFO. button on the remote control or press MENU
button to select Info. to display the Info. menu and check
"Lamp counter".
Reset lamp counter following to the procedure below:
1 Press and hold the ON/STAND-BY button on the projector
for more than 20 seconds.
2 The projector used time and lamp used time will be displayed
on the screen at least 5 seconds.
3 Press SELECT buttom for 5 second.
Counter
Projector
Lamp
Normal
Eco
Corresponding value
Lamp Total lamp used time
Info. menu
PC adjust
Display
Color adjust
Setting
Expand
Info.
-10-
Projector used time
650H
250H
400H
775H
Input
VGA IN 1
1024x768@60
H-sync freq.
48.3
KHz
V-sync freq.
59.9
Hz
Lamp status
Lamp counter
16 H
Power management
Ready
5 Min
Image Mode
Normal
Move
Next
Exit