Security Function Notice - Eiki LC-XNS2600 Service Manual

Security Function Notice

This projector provides security functions such as "Key lock", "PIN code lock" and "Logo PIN code lock". When the
projector has set these security function on, you are required to enter correct PIN code to use the projector. If you do not
know the correct PIN code to the projector, the projector can no longer be operated or started. In this case, you must reset
those function first according to the resetting procedure described below and then check up on the projector.
Resetting procedure
1. Disconnect the AC power cord from the AC outlet.
2. Press ON/STANDBY button and SELECT button together, and then connect the AC power cord.
-The PIN code lock functuon will be resect as initial PIN code after releasing key lock function.
Standby mode notice
This function can be used while operating the projector via network.
Normal ...Supply power to the projector even after turning off the projector.
You can turn on or turn off the projector,change network enviroment via series port.
Eco..........In this state, network function and VGA OUT are disable after turning off the projetcor.
When "Eco" is selected, some functions will be limited.
The functions below are limited in ECO mode:
Note:
 :Enable
 :Limited
Function Description
Locks operation of the side control or the remote
control.
Key lock If the Key lock is enabled with side control lock,
the projector can no longer be started.
Initial setting: Key lock function is disabled.
Prevents the projector from being operated by an
PIN code unauthorized person.
lock
Initial code: "111"
Function
Network
VGA out
Audio out
On start
RS-232C（power on）
ECO mode





-11-