Menu Level 3: Operating Mode - Waeco CoolAir CA-800-Universal-2 Installation Manual

CoolAir

6.3.4 Menu level 3: Operating mode

The system always starts with a defined operating mode for room tempe-
rature. This parameter can be configured:
➤ Start configuration mode (see chapter "Start and end configuration
mode" on page 30).
✓ The first digit of the display (see fig. 10 on page 6, Pos. 5) shows the
menu level and the second and third show the parameter which can
be set.
➤ Press the + button (see fig. 10 on page 6, 6) twice to switch to menu le-
vel 3.
➤ Press the operating mode button (see fig. 10 on page 6, Pos. 4) to
change the parameter.
✓ The digits in the display flash until the parameter you enter is confir-
med.
➤ Use the buttons + or - (see fig. 10 on page 6, Pos. 6 and 7) to select
the operating mode with which the system starts.
ID number
0
1
2
3
➤ Press the operating mode button (see fig. 10 on page 6, Pos. 4) to
confirm your entry.
✓ The set value is saved and is then used when the system is restarted.
✓ You are now in menu level 3 and can use the + and - buttons to switch
between menu levels.
Installation
Operating mode
Automatic mode
Operating mode 1
Operating mode 2
Operating mode 3
33