Menu Level 3: Operating Mode - Waeco CoolAir CA850S Installation Manual

CA-850S_EBA.book Seite 35 Mittwoch, 8. September 2010 7:31 19
Installation
➤ Use the + and – buttons (fig. 7 on page 5, item 6 and 7) to set the val-
➤ Press the Operating Mode button (fig. 7 on page 5, item 4) to con-
✓ The set value is saved and is then used when the unit is restarted.
✓ You are now in menu level 2 again and can use the + and – buttons to
6.3.4

Menu level 3: Operating mode

The unit always starts with a defined operating mode for room tempera-
ture. This parameter can be configured:
➤ Start configuration mode (see Chapter "Starting and ending configu-
✓ The first digit of the display (fig. 7 on page 5, item 5) shows the menu
➤ Press the + button (fig. 7 on page 5, item 6) twice to switch to menu
➤ Press the Operating Mode button (fig. 7 on page 5, item 4) to
✓ The digits in the display flash until the parameter you entered is con-
➤ Use the + and – buttons (fig. 7 on page 5, item 6 and 7) to set the
ue for low voltage shutdown. The characteristic figures at second and
third place on the digital display represent the voltage (V) at which the
unit is shut down:
Characteristic Low voltage
figure shutdown
22,2
1
22,4
2
22,6
3
22,8
4
22,9
5
firm your entry.
switch between menu levels.
ration mode" on page 33).
level and the second and third show the parameter which can be set.
level 3.
change the parameters.
firmed.
mode with which the unit starts up:
Characteristic fig-
Operating mode
ure
Automatic mode
0
Operating mode 1
1
Operating mode 2
2
Operating mode 3
3
Characteristic Low voltage
figure shutdown
23,0
6
23,1
7
23,2
8
23,4
9
23,6
10
CoolAir
35