Menu Level 3: Operating Mode; Menu Level 4: Default Setting - Waeco CoolAir CA850S Installation Manual

CA-850S_EBA.book Seite 35 Freitag, 16. April 2010 7:42 19
Installation
6.3.4

Menu level 3: Operating mode

The unit always starts with a defined operating mode for room tempera-
ture. This parameter can be configured:
➤ Start configuration mode (see Chapter "Starting and ending configu-
✓ The first digit of the display (fig. 7 on page 5, item 5) shows the menu
➤ Press the + button (fig. 7 on page 5, item 6) twice to switch to menu
➤ Press the Operating Mode button (fig. 7 on page 5, item 4) to
✓ The digits in the display flash until the parameter you entered is con-
➤ Use the + and – buttons (fig. 7 on page 5, item 6 and 7) to set the
➤ Press the Operating Mode button (fig. 7 on page 5, item 4) to con-
✓ The set value is saved and is then used when the unit is restarted.
✓ You are now in menu level 3 again and can use the + and – buttons to
6.3.5

Menu level 4: Default setting

You can reset the parameters you set in configuration mode on menu
levels 1 to 3 to the default settings:
➤ Start configuration mode (see Chapter "Starting and ending configu-
✓ The first digit of the display (fig. 7 on page 5, item 5) shows the menu
➤ Press the + button (fig. 7 on page 5, item 6) three times to switch to
✓ The digital display shows
➤ Press the Operating Mode button(fig. 7 on page 5, item 4), to reset
ration mode" on page 32).
level and the second and third show the parameter which can be set.
level 3.
change the parameters.
firmed.
mode with which the unit starts up:
Characteristic fig-
Operating mode
ure
Automatic mode
0
Operating mode 1
1
Operating mode 2
2
Operating mode 3
3
firm your entry.
switch between menu levels.
ration mode" on page 32).
level and the second and third show the parameter which can be set.
menu level 4.
the unit to the factory settings.
.
--
CoolAir
35