Table of Contents
Advertisement
User Password
If you want another user to have access only to your system but not to
setup, set a user' s password with the " System" option selected in the
BIOS Features Setup.
If you want a user to enter a password when trying to access setup, set
a user' s password with the " Setup" option selected in the BIOS Fea-
tures Setup. Using user' s password to enter Setup allows a user to
access only the " User Password" option that appears on the main
screen. Access to all other options is denied.
To set, confirm, verify, disable or delete a user' s password, follow the
procedures described in the section " Supervisor Password" . If you for-
get your password, refer to the procedure described in the same sec-
tion, " Supervisor Password" .
IDE HDD Auto Detection
This option detects the hard disk parameters for the hard disk drives
installed in your system. Highlight this option and press <Enter>. A
screen similar to the one below will appear.
HARD DISKS
Primary Master:
OPTIONS
SIZE CYLS HEAD
2 (Y)
853
1
853
3
853
Note: Some OS (like SCO-UNIX) must be "NORMAL" for installation
Enter your choice, and press <Enter> to accept the parameters or press
<Esc> to abort. The parameters of the hard disk will be displayed in the
Standard CMOS Setup.
60
ROM PCI/ISA BIOS
CMOS SETUP UTILITY
AWARD SOFTWARE, INC.
TYPE SIZE CYLS HEAD RECOMP LANDZ SECTOR MODE
Select Primary Master Option (N=Skip): N
RECOMP LANDZ SECTOR
827
32
0
1654
16
65535
1653
827
32
65536
1653
ESC: Skip
MODE
1653
63
LBA
63
Normal
63
Large
Advertisement
Table of Contents
