Installing Boxed Processor - DFI 686IPK User Manual

Installing Boxed Processor

1. Mount the two black plastic pegs onto the system board. These
pegs will be used to attach the fan heatsink supports. Notice that
one hole and the base of one peg are larger than the other hole
and peg base. Push each peg into its hole firmly until you hear it
" click" into place.
2. Slide a black plastic heatsink support onto each end of the fan
heatsink, making sure that the hole and clip are on the outside
edge of the support. (If the supports are reversed, the holes will not
line up with the pegs on the system board). Slide each heatsink
support toward the center of the processor until the support is
seated in the outside groove in the fan housing.
20