DFI 686IPK User Manual page 34

Connecting the USB Ports
As an option, one card-edge bracket mounted with two USB port cables
may be provided with the system board. The ends of the cables are
attached to a connector. Connect the USB cable connector to J1 on the
system board. The USB port cables can be inserted only if pin 1 of the
cable (red wire) is aligned with pin 1 of J1. Pin 9 of J1 has been re-
moved and the hole in the USB cable connector, which corresponds to
pin 9, has been plugged to prevent incorrectly inserting the connector.
Mount the card-edge bracket to the system chassis.
USB port cables (optional)
IrDA Connector
The 686IPK system board is equipped with an IrDA connector for wire-
less connectivity between your computer and peripheral devices. Con-
nect your IrDA cable to connector J2 on the 686IPK system board.
Make sure " Onboard IR Controller" in the Integrated Peripherals setup
of the Award BIOS is Enabled. Carefully read this section (Onboard IR
Controller) in Chapter 3 of this manual for instructions prior to using
your IrDA device.
34