DFI 686IPK User Manual page 57

Onboard IR Controller
The 686IPK system board supports IrDA function for wireless connectiv-
ity between your computer and peripheral devices. You may not use
IrDA (J2) and the COM 2 serial port (CN1) at the same time. If you are
using the COM 2 serial port, make sure " Onboard IR Controller" is Dis-
abled.
To use the IrDA function, follow the steps
below.
1. Connect your IrDA cable to connector
J2 on the 686IPK system board.
2. Set " Onboard IR Controller" to Enabled.
3. If Enabled, the following options will ap-
pear right after " Onboard IR Controller" .
IR Address Select
This is used to select an I/O address for the IrDA peripheral/device
installed. The options are: 3F8H, 2F8H, 3E8H and 2E8H. Default
setting: 2E8H.
IR Mode
Set " IR Mode" to the type of IrDA standard supported by your IrDA
peripheral/device. The options are: IrDA (HP mode) and ASKIR
(Sharp mode). Default setting: IrDA.
IR Transmission Delay
If this option is Enabled, transmission of data will be slower. This is
recommended when you encounter transmission problem with your
device. The options are: Enabled and Disabled.
IR IRQ Select
Selects an IRQ for the IrDA peripheral/device installed. The options
are: IRQ3, IRQ4, IRQ10 and IRQ11. The default setting is IRQ10.
57