Table of Contents
Advertisement
CONFIGURATION
+
SOFTNER REGENERATION
CONFIGURATION
+
LANGUAGE
CONFIGURATION
+
Paym. system
OFF
CONFIGURATION
+
DATA IN/OUT
CONFIGURATION
+
MEASUREMENT UNITS
CONFIGURATION
+
TURBOSTEAM
CONFIGURATION
+
time control
YES
CONFIGURATION
+
Standard data
NO
CONFIGURATION
+
Archive reset
YES
REGENERATION - includes the parameters for the softner regeneration: liters of
resin (da 0,1l a 25l), hardness (da 0 a 45 °F).
The display provides a choice of the following languages:
Italian, English, French, German, Dutch, Spanish, Portuguese and Japanese.
Payment system
DATA IN/OUT – contains three entries:
Key – indicates the key number from 0 to 60.
Data – IN transfer from smart card to machine. OUT transfer from
machine to smart card.
TX/RX – to start data transfer
MEASURING UNIT – includes 2 sub-menus
Temperature – can be set to °C Celsius centigrade or °F Fahrenheit
degrees.
Pressure – can be set to bar or psi.
TURBOSTEAM (Turbosteam) - includes 2 sub-menus
Stop steam temperature – indicates the automatic stop steam temperature
(Turbosteam). Can be set between a minimum
of 40 and a maximum of 85° C (104 – 185 ° F).
Regolator -
YES
NO
possible to set 4 different levels of emulsion.
If "NO" is set, a third line, "emulsion level", appears: here 4 levels can be chosen,
where 001 is less emulsion and 004 is continuous emulsion.
See paragraph "
the following pages.
Time check - view dispensing time on the display: YES/NO
Standard data – loads standard data. YES/NO
Archive reset – zeros the error log (malfunctions archive) stored on the machine:
YES/NO
71
" on
Hide quick links:
Advertisement
Table of Contents
