Advertisement
GO
Dim.
12.7 [.50]
Min. Typ
GAGE ELEMENT DIMENSIONS
HAND
TOOL
GO
46673
1.499-1.506
46673-1
[.0590-.0593]
1.702-1.709
46988
[.0670-.0673]
GO
Dim.
"W"
6.35 [.250]
Min. Typ
GAGE ELEMENT DIMENSIONS
HAND
TOOL
GO
46673
0.762-0.770
46673-1
[.0300-.0303]
1.016-1.024
46988
[.0400-.0403]
Figure 7
If the crimping chamber conforms to the gage
inspection, the tool is considered dimensionally
correct, and should be lubricated with a THIN coat of
any good SAE 20 motor oil. If not, the tool must be
returned for further evaluation and repair. Refer to
Section 6, REPLACEMENT AND REPAIR.
For additional information regarding the use of a plug
gage, refer to Instruction Sheet 408-7424.
Rev S
NO-GO
Dim.
50.8 [2.00]
Min. Typ
"R"
NO-GO
(Radius)
1.648-1.651
[.0649-.0650]
1.57
[.062]
1.851-1.854
[.0729-.0730]
NO- GO
Dim.
"W"
"W" (Width)
NO-GO
(Max)
1.267-1.270
[.0499-.0500]
3.05
[.120]
1.521-1.524
[.0599-.0600]
5.5. Ratchet Inspection
The ratchet feature on the hand tools should be
checked to ensure that the ratchet does not release
prematurely, allowing the jaws to open before they
have fully bottomed. Obtain a .025 mm [.001 in.] shim
that is suitable for checking the clearance between the
bottoming surfaces of the crimping jaws. Proceed as
follows:
1. Select the maximum size wire for the tool and a
terminal or splice.
2. Position the terminal or splice and wire between
the crimping jaws as described in Section 3.
3. Hold wire in place and squeeze tool handles until
the ratchet releases. Hold the handles in this
position, maintaining just enough tension to keep
the jaws closed.
Inspection of Wire
Barrel Section of
Crimping Chamber
Jaws Bottomed But
Not Under Pressure
GO Element Must Pass Completely
Through Crimping Chamber
NO-GO Element May Start Entry, But Must Not
Pass Completely Through Crimping Chamber
Figure 8
408-1535
Inspection of Insulation
Barrel Section of
Crimping Chamber
5 of 6
Advertisement
