Advertisement
TOOL
SIZE
(AWG)
46673
22-16
46673-1
46988
16-14
Figure 2
Edge of Wire Barrel Sleeve
Resting Against Locator
Terminal Tongue Through
Slot in Locator
Edge of Wire Barrel
Sleeve Resting Against
Locator
Open Section of Splice
in Slot in Locator
Closing the tool handles too tightly will deform the
NOTE
terminal or splice.
i
Rev S
WIRE
INSULATION
STRIP
RANGE
LENGTH
2.67-3.56
[.105-.140]
1.68-3.43
5.16 - 5.94
[.066-.135]
[.203 - .234]
3.05-4.32
[.120-.170]
Terminal Crimp
Wire Barrel
Sleeve
Insulation Barrel
Sleeve
Splice Crimp (First Crimp)
Wire Barrel
Sleeve
Insulation Barrel
Sleeve
2. To open the crimping jaws, close the tool handles
until the CERTI-CRIMP hand tool ratchet releases.
Note that the tool handles cannot be opened until
they are FULLY closed.
3. Push the locator up and, from the FRONT side of
the tool, insert the terminal or splice wire barrel
sleeve into the crimping jaws making sure that the
edge of the wire barrel sleeve rests against the
locator. See Figure 3 and Figure 4.
4. Close tool handles just enough to hold the
terminal or splice within the crimping jaws.
Push Locator Up So That
Terminal Tongue Slides
Through Slot in Locator
Figure 3
Push Locator Up So That
Splice Slides Through
Slot in Locator
Figure 4
5. Insert wire conductor through the insulation barrel
sleeve and into the wire barrel sleeve until it is flush
with the outer edge of the wire barrel sleeve. See
Figure 3 and Figure 4.
408-1535
Back Side of Tool
Insert Wire Conductor
Through Insulation Barrel
Sleeve and into Wire Barrel
Sleeve
Back Side of Tool
Insert Wire Conductor
Through Insulation Barrel
Sleeve and into Wire
Barrel Sleeve
2 of 6
Advertisement
