Advertisement
The wire barrel sleeve on high-temperature
NOTE
terminals and splices is color coded orange. Heat-
resistant terminals and splices are not color coded.
i
Refer to Figure 5]
Terminal
Splice
Wire
Barrel
Sleeve
Figure 5
6. Hold wire in place and close the tool handles
FULLY to crimp the terminal or splice. Allow tool
handles to open FULLY. Remove the crimped
terminal or splice from the crimping jaws.
7. To crimp the other half of the splice, reposition the
uncrimped sleeve in the crimping jaws as described
in Step 3. Follow Steps 4 through 6 to complete the
crimp.
No Wire Conductor
Strands Protruding
Rev S
Wire
Barrel
Sleeve
Insulation
Barrel
Sleeve
Insulation
Barrel
Sleeve
Crimp Centered on
Wire Barrel Sleeve
Figure 6
If the splice cannot be turned around to position the
NOTE
uncrimped sleeve in the crimping jaws, turn the tool
around.
i
8. Inspect the crimp. Refer to Figure 6 for a properly
crimped terminal and splice. Check the insulation
grip on the crimped terminal or splice. Refer to
Section 4, INSULATION CRIMPING
ADJUSTMENT.
The hashmark code on the bottom of the wire
NOTE
barrel sleeve created by the tool should match the
hashmark code referenced with the appropriate
i
tool. See Figure 6.
4. INSULATION CRIMPING ADJUSTMENT
The hand tool has three insulation crimping
adjustment positions to adjust the wire insulation grip:
1-Tight, 2-Medium, and 3-Loose. To obtain the desired
insulation grip, proceed as follows:
1. Insert insulation crimping adjustment pins into
Position 3 as shown in Figure 1.
2. Position terminal or splice in crimping jaws as
described in Section 3, Step 3.
3. Insert an UNSTRIPPED wire into only the
insulation barrel sleeve of the terminal or splice.
Tool 46673 and 46673-1
1 Hashmark
Tool 46988
2 Hashmarks
408-1535
1 Hashmark on
Bottom of Terminal
2 Hashmarks on
Bottom of Splice
3 of 6
Advertisement
