Advertisement
2. Position the product in the crimping chamber
according to Paragraph 3.1, Steps 1 through 5 or
Paragraph 3.2, Steps 1 through 6.
3. While holding the wire in place, squeeze the tool
handles together until the ratchet releases. Holding
the tool in this position, maintain just enough
pressure to keep the jaws closed.
4. Check the clearance between the bottoming
surfaces of the jaws. If the clearance is .025 mm
[.001 in.] or less, the ratchet is satisfactory. If
clearance exceeds .025 mm [.001 in.], the ratchet
is out of adjustment and must be repaired. Refer to
Section 6, REPLACEMENT AND REPAIR. If the
tool conforms to this inspection procedure,
lubricate it with a THIN coat of any good SAE 20
motor oil, and return it to service.
6. REPLACEMENT AND REPAIR
Customer--replaceable parts are listed in Figure 10.
Rev T
A complete inventory should be stocked and
controlled to prevent lost time when replacement of
parts is necessary. Parts other than those listed
should be replaced by TE to ensure quality and
reliability. Order replacement parts through your
representative, or call 1--800--526--5142, or send a
facsimile of your purchase order to 717--986--7605, or
write to:
CUSTOMER SERVICE (038--035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105--3608
For customer repair service, call 1--800--526--5136.
7. REVISION SUMMARY
Revisions to this instruction sheet include:
Updated document to corporate requirements.
S
Added tool number 68343--1.
S
408- 1559
9 of 10
Advertisement
