Table of Contents
Advertisement
Power and GPIO Connections
The camera uses a single 12-pin Hirose male connector for power, trigger, and strobe signals. The
suggested female cable mating connector is the Hirose model HR10A-10P-12S.
12-Pin Hirose Connector Signal Details
The following figure shows the pinout identification when looking at the camera's 12-pin male
Hirose connector. The table below lists the I/O signal connections.
Pin Number
Input / Output
1
2
3
Output
4
Output
5
Input
6
Input
7
Output
8
Output
9
10
11
12
The wire gauge of the power cable should be sufficient to accommodate a surge during power-up of
at least 3 amps with a minimum voltage drop between the power supply and camera. The camera
can accept any voltage between +12 and +24 Volts. If there is a voltage drop between the power
supply and camera, ensure that the power supply voltage is at least 12 Volts plus this voltage drop.
The camera input supply voltage can be read using CamExpert. Refer to the section on Voltage &
Temperature Measurement for more details.
Linea HS 32k CMOS TDI Cameras
1
9
2
10
3
11
12
4
5
Figure 8: 12-pin Hirose Pin Numbering
Table 9: 12-pin Hirose pin assignment
Signal Details
Power Ground
+12 V to +24 V power
Line 3 Out
Line 4 Out
Line 1/ Trigger / Phase A
Line 2 / Scan Direction/Phase B
Line 5 Out
Line 6 Out
Power Ground
+12 V to +24 V power
Signal Ground
Signal Ground
8
7
6
Notes
0 to 3.3 V TTL
0 to 3.3 V TTL
0 to 3.3 V TTL
0 to 3.3 V TTL
0 to 3.3 V TTL
0 to 3.3 V TTL
Note: intended as a return path for
GPIO signal and not intended as a
power ground
Note: intended as a return path for
GPIO signal and not intended as a
power ground
The Linea HS 32k TDI Camera 21
Advertisement
Table of Contents
