Installation Notices; Required Tools; How To Mount The Antenna Unit - Furuno SCX-20 Operator's Manual

1.5.1

Installation notices

• Do not install the unit on an uneven surface.
• DO NOT apply the adhesive to the four vent holes near the name plate.
1.5.2

Required tools

The following tools should be prepared in advance for this installation.
Electrical Drill
Drill Bit
Hole Saw
File
Phillips-head Screwdriver
1.5.3

How to mount the Antenna Unit

1. Attach the pole mount kit to the antenna base referring to subsection 1.3.3.
Note: The pipe included in the pole mount kit is not used.
2. Set the antenna base to the mounting location considering the tilt direction, and
make four mounting holes (4.2 to 5 mm) on the mounting platform.
Note: The possible tilt direction of the antenna base depends on the setting posi-
tion of the antenna base.
3. Make an antenna cable hole (25±2 mm) at the
center of the four mounting holes for passing
the supplied NMEA 2000 antenna cable
through the mounting platform.
Name plate Name plate
Bottom view of the antenna unit
Name
For making the mounting holes
4.2 to 5
For making the cable hole (25 mm)
For smoothing the cut edge of the cable hole
#2
Bow mark
1. INSTALLATION
Vent hole (four places) Vent hole (four places)
Note: Do not apply the Note: Do not apply the
adhesive here. adhesive here.
Remarks
Right Angle
Mounting Base
Make mounting
holes (4 places).
Platform Platform
Cable hole (ø25±2 mm)
1-11