System] Menu - Furuno SCX-20 Operator's Manual

2.4

[System] Menu

You can check the system information, perform diagnostic tests and restore the fac-
tory defaults from the [System] menu.
[System Information]
[Main PCB]
[Starter Version]
[Booter 1 Version]
[Booter 2 Version]
[Application Version]
[Serial No.]
[GNSS 1]
[GNSS 2]
[GNSS 3]
[GNSS 4]
[CAN Unique Number]
[CAN Address]
[Powered Time]
[Overall Powered Time]
[Simple Diagnostic Test]
[ROM]
[RAM]
[Rate Gyro Status]
[Accelerometer Status]
[Magnetic Sensor Status]
[Press./Temp. Sensor Status] Air pressure/temperature sensor status (Good or
[Installation Status]
[GNSS 1 Status]
[GNSS 2 Status]
[GNSS 3 Status]
[GNSS 4 Status]
[Antenna 1 Status]
[Antenna 2 Status]
[Antenna 3 Status]
[Antenna 4 Status]
Menu item Description
Main board version.
Starter application software version.
Booter 1 application software version.
Booter 2 application software version.
Main application software version.
Serial number for your SCX-20.
GNSS cores (1 to 4) software version.
CAN unique ID for the SCX-20.
CAN address assigned to the SCX-20.
Time since the SCX-20 was last turned on.
Total operation time of the SCX-20.
ROM test result (OK or NG (No Good)).
RAM test result (OK or NG (No Good)).
Rate gyro status (Good or Bad).
Accelerometer status (Good or Bad).
Magnetic sensor status (Good or Bad).
Bad).
Show the number of excessive vibrations detected at
the installation location.
GNSS 1 thru 4 status (Good or Bad).
Antenna 1 thru 4 status (Good or Bad).
2. INITIAL SETTINGS
2-5