Sensor] Menu - Furuno SCX-20 Operator's Manual

2.2

[Sensor] Menu

In order to display data correctly, enter the ship's dimensions, SCX-20 installation lo-
cation and adjust the sensor offset values as required on the [Sensor] menu.
Menu item
[Offset]
[HDG]
[Pitch]
[Roll]
[SOG/3-Axis
Speed]
[Air Pressure]
[Air Temperature]
[Smoothing]
[SOG/COG]
[3-Axis Speed]
[ROT]
[DR Time]
[DR Time]
[Ship Size, ANT/CALC-SPD Position]
Enter the appropriate value according to the ship's size, to improve the accuracy
of the 3-axis speed. The reference position for installation location and calculating po-
sition of the 3-axis speed is shown in the following figure:
Reference
position
( 0.0 )
[Ship's Width]
[Ship's Length]
[Ship's Height]
Offset the heading angle. When the heading angle is skewed right,
enter a negative value. When the heading angle is skewed left, en-
ter a positive value.
Offset the pitch angle.
Offset the roll angle.
Offset the speed value.
Offset the air pressure value.
Offset the air temperature value.
Set the time delay (smoothing) for SOG/COG data output.
Set the time delay (smoothing) for 3-Axis Speed data output.
Set the time delay (smoothing) for ROT data output.
When the SCX-20 cannot receive the signal from the satellite, the
SCX-20 continues to output heading data as "dead reckoning" for
the time set here. If the signal from the satellite cannot be retrieved
with in the time set here, the SCX-20 stops outputting the heading
data.
Z ( + )
Ship bottom line
Ship's length
Set the ship's width, calculated from the port-side to starboard-side
of the widest section of the vessel (Setting range: 1.0 to 999.9 m).
Set the ship's length, calculated to the bow-tip to the stern, along
the center of the vessel (Setting range: 1.0 to 999.9 m).
Set the ship's height, calculated to the bottom of the keel to the top
f the mast (Setting range: 1.0 to 199.9 m).
Description
Reference
position
( 0.0 )
X (-)
Draft position
Y ( + )
2. INITIAL SETTINGS
X ( + )
Y ( + )
Ship's width
2-3