MIMAKI TS500 Daily Care Manual

TS500/Tx500 Daily Care
With a view to using this machine in a better condition, please be sure to the following daily care
daily work. Please refer to "Daily care manual" for the detail.

Cleaning of around the heads

1. Perform [HEAD MAINT.], move the carriage to the
maintenance position and open the left maintenance cover.
(1) Press the
MAINT.
(2) Press the
(3) Press
(4) Press the
(5) Open the left maintenance cover.
2. Soak the clean stick or the waste cloth in the maintenance cleaning liquid and wipe off an
accumulated ink on the side of the head and on the bottom surface of the slider.
Side surface of the head (shown in deep gray)
Nozzle part Bottom surface of the slider (shown in gray)
3. Soak the COTTON CIEGAL
the cap rubber attached on the nozzle surface from the rear side to the front side.
COTTON CIEGAL
4. Close the left maintenance cover.
5. Press
© 2013 MIMAKI ENGINEERING CO., LTD.
key in LOCAL.
key.
to select [HEAD MAINT.].
key.
• Do not touch the nozzle surface, because the cleaning will be performed in the procedure
No.3.
®
in the maintenance cleaning liquid and wipe off the mark of
®
• Immerse much enough so that maintenance liquid may drip from it.
• Do not wipe the nozzle surface with dry COTTON CIEGAL
®
• If COTTON CIEGAL has fluffed, replace it.
• If ink solid adheres to COTTON CIEGAL
replace it.
, complete the cleaning.
Make sure to wear the attached
goggles and glove
Left maintenance
cover
[Before cleaning]
[Before cleaning]
Mark of the cap
®
.
®
, change the surface to use for cleaning or
M014553-01(D202546-11)-28082013
when you work.
after at the end of the
[After cleaning]
[After cleaning]
IT