Table of Contents
Advertisement
Chapter 3
Scanning Operations
3
3.1 Creating a New File
3-2
Applied Biosystems
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Once you start up the CytoFluor system as described in
Chapter 2, Getting Started, you can create a new file. To do
this, you have several options. See this chart for details:
You can...
Enter new settings and
create a new file name.
Access the data of a pre-
existing file to adopt the
settings of that file
Set the scan parameters
through the CytoFluor
main setup screen
before naming the file.
NOTE: The scan parameters enable you to enter
information unique to the experiment. You can select the
run mode, mix time, reads per well, and so on. See
Section 3.2, Setting Scan Parameters, for details. You can
save a file and enter a new file name before or after you set
the scan parameters. See the following sections for details.
For instructions...
See Section 3.1.1, Creating a
New, Original File.
NOTE: If you do not have an
existing file in the system,
follow the steps in this section
to create one.
See Section 3.1.2, Accessing
a Previously Saved File.
See Section 3.2, Setting Scan
Parameters.
Advertisement
Table of Contents
