BWI Eagle AIR-EAGLE XLT Product Information Bulletin

AIR-EAGLE
900 MHz RF Transmitter
MODEL 441-1400-DC
DESCRIPTION
The A -E XLT TX s an R.F. transmitter capable of sending four
IR AGLE I
independent dry-contact input commands to an Air-Eagle XLT
Receiver located up to 2500 feet away (longer ranges can be achieved
with external high gain antennas) Any number of transmitters and
receivers can be combined to create a medium range radio frequency
system that operates hazardous or hard-to-reach electrical apparatus
from safe, convenient locations. Seven user-selectable frequencies
allow multiple systems to operate simultaneously in the same area
without interference.
APPROVALS
United States (FCC)
Canada (IC)
INSTALLATION
Mount the A -E XLT TRANSMITTER in a convenient location.
IR AGLE
1.
Install wiring to contact input terminal strip (Note – the terminal block
2.
header lifts off the base for easy wiring)
3. Make desired repeater mode and frequency selections using
instructions on page 2.
4. Attach supplied antenna to connector on right side of unit.
5. Connect DC power to the proper terminals in your control circuit.
TERMINAL STRIP WIRING
Wire as shown based on number of contact inputs
1 2 3 4
GENERAL OPERATION
A closure on any input transmits its channel command to activate the
corresponding relay in the remote receiver. The transmission continues as
long as the input is closed and ceases when the input opens.
105 Bonnie Drive
Butler, PA 16002
724-283-4681
724-283-5939 (fax)
www.bwieagle.com
®
XLT
MCQ-XB900HP
1846A-XB900HP
5 6 7 8 9
PRODUCT INFORMATION
Dimensions (with mounting plate) 6.3" L x 4.8" W x 2.3" H
CONTROLS & INDICATORS
10
TX LED
Dry Contact Inputs
SEL2
SEL1
BULLETIN
Illuminates green when power is applied.
Changes to red while any contact input is
closed and unit is transmitting.
Transmits individual RF codes to the receiver
Dip switch bank for digital address selection
Dip switch bank for frequency & repeater
mode selection