BWI Eagle AIR-EAGLE XLT Product Information Bulletin

AIR-EAGLE
900 MHz RF Transmitter
MODEL 44-1400-120I-120VAC
DESCRIPTION
The A -E XLT TX s an R.F. transmitter capable of sending four
IR AGLE I
120VAC input commands to an Air-Eagle XLT Receiver located up to
2500 feet away (longer ranges can be achieved with external high gain
antennas) Any number of transmitters and receivers can be combined
to create a medium range radio frequency system that operates
hazardous or hard-to-reach electrical apparatus from safe, convenient
locations. Seven user-selectable frequencies allow multiple systems to
operate simultaneously in the same area without interference.
APPROVALS
United States (FCC)
Canada (IC)
INSTALLATION
Mount the A -E XLT TRANSMITTER in a convenient location.
1. IR AGLE
Install wiring to input terminal strip (Note – the terminal block header
2.
lifts up off the base for easy wiring)
3. Attach supplied antenna to connector on right side of unit.
4. Plug supplied AC wall plug adapter into AC outlet.
TERMINAL STRIP WIRING
Wire as shown based on number of contact inputs
1 2 3 4 5
GENERAL OPERATION
Transmission occurs when 120VAC is applied to the input. Transmission
continues while 120VAC is present and ceases when 120VAC is
removed.
105 Bonnie Drive
Butler, PA 16002
724-283-4681
724-283-5939 (fax)
www.bwieagle.com
®
XLT
MCQ-XB900HP
1846A-XB900HP
6 7 8 9
PRODUCT INFORMATION
Dimensions (with mounting plate) 6.3" L x 4.8" W x 2.3" H
CONTROLS & INDICATORS
10
TX LED
Voltage Inputs
SEL2
SEL1
BULLETIN
Illuminates green when power is applied.
Changes to red while voltage is applied to
any input and unit is transmitting.
Transmits individual RF codes to the
receiver
Dip switch bank for digital address selection
Dip switch bank for frequency selection