AIR-EAGLE
900 MHz RF Transceiver
MODEL 441-6000-120VAC
DESCRIPTION
The A
-E
XLT RF T
IR
AGLE
RANSCEIVER IS
transmit and receive unique signals from an identical unit located up to
2500 feet away (longer ranges can be achieved using external antennas).
This model comes equipped with two contact inputs and two 5-amp SPDT
relay outputs. This allows the user to not only transmit information out but
receive a confirming signal back that the operation was performed. The
Air-Eagle XLT TRX is user-programmable for up to eight network
frequencies to allow multiple systems to operate simultaneously in the
same area and utilizes spread-spectrum technology and provides the
utmost security and reliability even in the noisiest RF environments.
APPROVALS
United States (FCC)
Canada (IC)
INSTALLATION
DISCONNECT Power from all equipment before installation.
1.
Mount the A
-E
XLT T
IR
AGLE
2.
Install control wiring to terminal strip.
3.
Make desired relay operation, repeater mode and frequency
selections using instructions on page 2.
4.
Install antenna onto connector located on the right side on the
enclosure.
5.
Plug supplied AC wall plug adapter into AC receptacle.
PC BOARD SET-UP INFORMATION
Make the following connections on the PC Board Terminal Strip (TER1)
TERMINAL STRIP WIRING (TER1)
Terminal 1
Negative (-) 9-36VDC INPUT from wall adapter
Terminal 2
Positive (+) 9-36VDC INPUT from wall adapter
Terminal 3
CH1 Dry Contact Input (Common)
Terminal 4
CH1 Dry Contact Input
Terminal 5
CH2 Dry Contact Input (Common)
Terminal 6
CH2 Dry Contact Input
Terminal 7
CH3 Dry Contact Input (Common)
Terminal 8
CH3 Dry Contact Input
Terminal 9
CH1 Relay N/O
Terminal 10
CH1 Relay C
Terminal 11
CH1 Relay N/C
Terminal 12
CH2 Relay N/O
Terminal 13
CH2 Relay C
Terminal 14
CH2 Relay N/C
105 Bonnie Drive
Butler, PA 16002
724-283-4681
724-283-5939 (fax)
www.bwieagle.com
®
XLT
a dual I/O unit designed to
MCQ-XB900HP
1846A-XB900HP
in a convenient location.
RANSCEIVER
PRODUCT INFORMATION
BULLETIN
CONTROLS & INDICATORS
Illuminates Green when power is applied,
POWER/TX LED
changes to Red when transmitting.
Green LED illuminates continuously while relay
LED1
#1 is energized
Green LED illuminates continuously while relay
LED2
#2 is energized
Transmit individual RF codes to the remote
Dry Contact Inputs
transceiver
REL1 & REL2
Two SPDT output control relays
RF Module that transmits/receives data for
RF1
corresponding unit