AIR-EAGLE
900 MHz RF Transmitter
MODEL 441-1400-DCI-DC
DESCRIPTION
The A
-E
XLT TX
s an R.F. transmitter capable of sending four
IR
AGLE
I
independent 5-24VDC input commands to an Air-Eagle XLT Receiver
located up to 2500 feet away (longer ranges can be achieved with
external high gain antennas) Any number of transmitters and receivers
can be combined to create a long range radio frequency system that
operates hazardous or hard-to-reach electrical apparatus from safe,
convenient locations. Seven user-selectable frequencies allow multiple
systems to operate simultaneously in the same area without
interference.
APPROVALS
United States (FCC)
Canada (IC)
INSTALLATION
Mount the A
-E
XLT TRANSMITTER in a convenient location.
IR
AGLE
1.
Install wiring to input terminal strip (Note – the terminal block header
2.
lifts off the base for easy wiring)
3.
Make desired repeater mode and frequency selections using
instructions on page 2.
4.
Attach supplied antenna to connector on right side of unit.
5.
Connect DC power to the proper terminals in your control circuit.
TERMINAL STRIP WIRING
Wire as shown based on number of voltage inputs
1
2
3
4
GENERAL OPERATION
Transmission occurs when 5-24VDC is applied to the input. Transmission
continues while 15-24VDC is present and ceases when 5-24VDC is
removed.
105 Bonnie Drive
Butler, PA 16002
724-283-4681
724-283-5939 (fax)
www.bwieagle.com
®
XLT
MCQ-XB900HP
1846A-XB900HP
5
6
7
8
9
PRODUCT INFORMATION
Dimensions (with mounting plate) 6.3" L x 4.8" W x 2.3" H
CONTROLS & INDICATORS
10
TX LED
Voltage Inputs
SEL2
SEL1
BULLETIN
Illuminates green when power is applied.
Changes to red while any contact input is
closed and unit is transmitting.
Transmits individual RF codes to the receiver
Dip switch bank for digital address selection
Dip switch bank for frequency & repeater
mode selection