Related Manuals for BWI Eagle 441-HH-4
Summary of Contents for BWI Eagle 441-HH-4
- Page 1 AIR-EAGLE XLT 441-HH-4 900 MHz RF Transmitter Document Date: 7/20/2022 Product Rev: 12...
-
Page 2: Warranty Statement
441-HH-4 WARRANTY STATEMENT BWI Eagle Inc. warrants the Air-Eagle Remote Control System, if properly used and installed, will be free from defects in material and workmanship for a period of 1 year after date of purchase. Said warranty to include the repair or replacement of defective equipment. This warranty does not cover damage due to external causes, including accident, problems with electrical power, usage not in accordance with product instructions, misuse, neglect, alteration, repair, improper installation, or improper testing. -
Page 3: Controls And Indicators
441-HH-4 INTRODUCTION The Air-Eagle XLT TX is a handheld R.F. transmitter capable of sending up to four unique digital commands to an Air-Eagle XLT Receiver located up to 2500 feet away. Any number of transmitters and receivers can be combined to create a medium-range radio frequency system that operates hazardous or hard-to-reach equipment from safe, convenient locations. -
Page 4: Frequency Programming
441-HH-4 FREQUENCY PROGRAMMING Please read through these instructions completely before beginning programming procedure! At any time, you can check the current frequency setting by depressing Buttons 3 & 4 simultaneously, for approximately 5 seconds, until the TX LED is illuminated RED. Then release the buttons and watch as the TX LED stays RED for about 8 seconds, goes out, then begins to blink. - Page 5 441-HH-4 TRANSMITTING MODE SET-UP Please read through these instructions completely before beginning programming procedure! The transmitter can be set to be in a standard transmission mode or in a repeater mode where all receivers will repeat the transmission. To select transmission mode: 1.
-
Page 6: Specifications
441-HH-4 SPECIFICATIONS Durable Sealed Membrane Keypad – Eliminates Dust, Dirt and Keypad Moisture Failures Enclosure ABS UL94 HB Enclosure with ring is rated IP54 *Not Protective Ring SEBS (TPE) Waterproof Power Requirements 3.0 VDC (2) 1.5V lithium each, size AAA, to equal 3.0VDC nominal.